Kaba-Mas #3 strike to work with the CDX-09, CDX-10, and DKX-10 Lock Extensions. Use on standard inswinging doors.

Kaba-Mas #2 strike to work with the CDX-09, CDX-10, and DKX-10 Lock Extensions. Use on standard out-swinging doors.

If a Sargent & Greenleaf Model 2740B's low battery warning signal is ignored for approximately one hundred openings, the lock will go into a "Lock Open Latch" condition. This prevents the lock from locking, but can be reset using a "444 Device" and a...

Model 2740B High Security Lock.  NSN 5340-01-613-2080 (GSA) - NSN 5340-01-628-4750 (DLA) Sargent and Greenleaf safe locks have been protecting the assets of banks, businesses and governments for more than 150 years. The S&G Model...

Replacement Will-Burt thumb latch button.  Used on Will-Burt, Diebold-Mosler, and Mosler drawers.

Kaba-Mas #9 strike to work with the CDX-09, CDX-10, and DKX-10 Lock Extensions. Use on out-swinging double doors and out-swinging doors without a door jamb.

Replacement cable assembly for the Kaba-Mas X-10 high security lock.  These are shorter than standard length cables, which can make installation easier by eliminating some of the excess length of the cables.   Cable length will accommodate...

Replacement dial assembly for the Sargent & Greenleaf model 2937 combination lock. This dial is not intended for use with other models of locks. Resources:  S&G 2937 Instructions  (510 KB)  S&G 2937 Data...

Z-Spring for S&G 2937 & 8500 Series Locks

Replacement Liquid Crystal Display (LCD) for the Kaba-Mas X-10.  This is the lighted display used in X-10 locks manufactured on or after March 25, 2014.  The display will work in X-08, X-09 and X-10 locks manufactured prior to 3/25/2014,...

When and how to use the X-08 / X-09 LOBC FIXTURE: Note: Before performing any type of service on any X-08 or X-09 lock, be certain you are thoroughly familiar with the lock's operating procedures. Installation and operating information is available on...

This conversion kit adapts a Kaba-Mas X-10, CDX-10 or DKX-10 to fit doors or drawers up to 10 inches thick.  Thickness is measured from the combination lock's mounting surface to the dial ring's mounting surface. Kit includes longer spindle, inner...

Kaba-Mas #1 strike to work with the CDX-09, CDX-10, and DKX-10 Lock Extensions. Use on in-swinging doors with wooden door jambs.  

Replacement Dial with Spindle for Sargent & Greenleaf Lock Model 2740.

The 3M™ 2209 Disposable Grounding Wrist Strap provides cost effective and reliable static discharge protection. It is ideal for protecting your investment when installing a new electronic safe lock or replacing an electronic lock's keypad. Wearing...

This is the size driver needed to remove the small screw when replacing the flex cables on an X-10, X-09, or X-08.  This inexpensive tool will come in very handy when needed.  Using a small Allen or hex wrench cannot tighten the screw enough to...

Access Control Model for S&G 2890

Replacement dial ring and dust cover for the Sargent & Greenleaf model 2937 combination lock. This dial ring is not intended for use with other models of locks. Resources:  S&G 2937 Instructions  (510...

Replacement dust cover for Sargent & Greenleaf government combination locks.  Fits over the dial ring of the Model 2937 mechanical combination lock and the Models 2740A and 2740B electromechanical combination locks. This dust cover is a...

#2 Strike for Out-Swing Door Used with S&G Brute Deadlatch Lock