Hardened Repair Pins, 5/16" x .400" (5-Pack)

Hardened Pins for Safe Repair, designed and manufactured by industry expert Joe Reustle.

No need to cut these to length like taper pins.  Pre-cut to .400" length.  One end of each pin features a slight chamfer to make it easier to start the pin into the hole.

Designed for use in holes drilled with 5/16" carbide bits.  Diameter of pin is slightly larger than 5/16" (approximately .025" larger) to accommodate the oversized tips found on carbide tipped drill bits.

Hardened up to Rockwell 63.

Pack of 5.