S&G Automatic Door Operator Kit for 2890C Panic Device Models (S&G ABR Kit Also Required)

S&G Automatic Door Operator Kit for 2890C

• By combining the automatic door operator (ADO) with Automatic Bolt Retraction (ABR), you can ensure that you are 100% ADA compliant.
• The ADO Kit includes 2 of the ADA access buttons that can be installed on either side of the door and the operator which is installed on the door.
• This will pair with the Automatic Bolt Retraction (ABR) so that when the access button is pushed from the outside, but the RFID chip is not swiped the client's door will not open. If the RFID chip is swiped and passed when pressing the access button the door will automatically open.
• From the inside of the door, which does not require RFID access, the access button will automatically open the door.

The 2890C ABR and ADO kits are GSA approved for use with the following types, which are to be wired into existing electronic access control systems:

• Type II (Primary doors, handle on the interior side.)
• Type IV (Primary doors, panic bar on the interior side.)
• Type VII(Secondary doors, handle on the interior side.)
• Type VIII (Secondary doors, panic bar on the interior side.)

ADO Features:
The S&G ADO solution is a non-pivot drive and combination of belt, gear and pulley for less torque, less power, absorbs more abuse, and is quieter than other automatic door openers while complying with all US and Canadian ADA requirements.

• ADA Compliant
• Meets ANSI A156.19
• Certified for use as fire door operators (3-hour rating)
• Self-Tuning, Self-Learning
• Minimum 5 seconds from close to open
• Stays open for 5 seconds
• Force: 15 lbs-6.8 kg
• Push or Pull (In door, Out swing)
• Activation: Knowing Act
• Optional Safety Device
• Power: 1A, 100W
• Non-Handed
• Extremely Quiet Operation

Resources:

• S&G 2890C ABR/ADO System Brochure